标题: Simpoe--A very good ploymer flow analysis software [打印本页] 作者: zelda 时间: 2005-2-24 13:31 标题: Simpoe--A very good ploymer flow analysis software I used Moldex express before. Last time it run under Solidwork,a nd it called Moldexwork. Not doing detailed analysis, i think MPA or even Cmold 3D quickfill is better,the programmer is a lady, purpose is to bring you to fall into Moldex.Anyway, I can tell you using Moldex3D is a very very very painful experience.I started using Moldex before it is commercial, it was called CAEMOLD. Until today, nothing much has been improved on the kernel. There is another good polymer flow program in Taiwan call "Simpoe", visit this website for more information https://www.simpoe-mold.com. It has 3D simulation too. Price is even cheaper than Moldex.But it is workable and practical!作者: zelda 时间: 2005-2-24 13:32
I used this product before. Last time it run under Solidwork. Not doing detailed analysis, i think MPA or even Cmold 3D quickfill is better,the programmer is a lady, purpose is to bring you to fall into Moldex.Anyway, I can tell you using Moldex3D is a very very very painful experience.I started using Moldex before it is commercial, it was called CAEMOLD. Until today, nothing much has been improved on the kernel. There is another good polymer flow program in Taiwan call "Simpoe", visit this website for more information https://www.simpoe-mold.com. It has 3D simulation too. Price is even cheaper than Moldex.But it is workable and practical!作者: aniu5460 时间: 2005-4-22 14:04
英文的怎么不翻译一下啊？