标题: UG NX3 CAE [打印本页] 作者: jeffrey shi 时间: 2005-11-27 21:34 标题: UG NX3 CAE My question is how to analyse an assembly directly after I have an assembly in NX3?
Should I do any special preprocess for the modeling? Thanks a lot作者: zxjgeorge 时间: 2005-12-11 13:48
join all作者: dongjl 时间: 2005-12-16 22:04
好深奥呀作者: flanker-forever 时间: 2005-12-19 14:51
看教程。关于装配的分析有说明，用MATE。作者: htl_jk 时间: 2005-12-23 11:49
原帖由 jeffrey shi 于 2005-11-27 21:34 发表
My question is how to analyse an assembly directly after I have an assembly in NX3?
Should I do any special preprocess for the modeling? Thanks a lot