标题: Need expert help on this product [打印本页] 作者: syyong 时间: 2006-5-24 09:01 标题: Need expert help on this product Hi Need expert help how to make the "taper" for this prodct and also the parting line.作者: syyong 时间: 2006-5-24 09:03 标题: Top unit Don't have taper作者: syyong 时间: 2006-5-24 09:04 标题: bottom unit This also without "taper"作者: syyong 时间: 2006-5-24 09:13
This is part file, Can someone help me to "show" me step by step for how to create the taper for the product. How to make the parting line and mould.作者: syyong 时间: 2006-5-24 09:34
part file作者: 小老大 时间: 2006-5-24 09:40
no part no办法作者: syyong 时间: 2006-5-24 09:44
here作者: syyong 时间: 2006-5-24 09:45
2/5作者: syyong 时间: 2006-5-24 09:46
3/5作者: syyong 时间: 2006-5-24 09:48
4/5作者: syyong 时间: 2006-5-24 09:50
5/5
Currently I’m using UGNX2, just migrate from NX1 which without mould wizard feature. Appreciate if someone can tech me step by step by using Mould Wizard (NX2).作者: 小老大 时间: 2006-5-24 11:20
parting line作者: syyong 时间: 2006-5-24 13:28
Thanks a lot.
Before we make the mould, we should make the part to be "taper". May I know what are the comman to removed all the "Radius" of the part作者: syyong 时间: 2006-5-25 09:43
hi 版主,
what are the best way to removed the "radius", so that I can do the "taper" for the parts
thanks in advance作者: 小老大 时间: 2006-5-25 10:56
原帖由 syyong 于 2006-5-25 09:43 发表
hi 版主,
what are the best way to removed the "radius", so that I can do the "taper" for the parts
不懂E 文