打开文件的信息是这样的：
Opening the assembly: 'doublelink_assy'...
Opening the rear suspension subsystem: 'doublelink'...
Assembling subsystems...
Assigning communicators...
WARNING: The following input communicators were not assigned during assembly:
testrig.cil_jack_frame (attached to ground)
testrig.cir_jack_frame (attached to ground)
testrig.cis_driveline_active
testrig.cis_leaf_adjustment_steps
testrig.cis_powertrain_to_body (attached to ground)
testrig.cis_steering_rack_joint
testrig.cis_steering_wheel_joint
testrig.cil_diff_tripot
testrig.cir_diff_tripot
testrig.cil_suspension_upright (attached to ground)
testrig.cir_suspension_upright (attached to ground)
doublelink.cil_subframe_front_to_body (attached to ground)
doublelink.cir_subframe_front_to_body (attached to ground)
doublelink.cil_subframe_rear_to_body (attached to ground)
doublelink.cir_subframe_rear_to_body (attached to ground)
doublelink.cil_strut_to_body (attached to ground)
doublelink.cir_strut_to_body (attached to ground)
doublelink.cil_trail_to_body (attached to ground)
doublelink.cir_trail_to_body (attached to ground)
Assignment of communicators completed.
Assembly of subsystems completed.
Suspension assembly ready.
在接下来的仿真过程中，有这样一条警告：
---- WARNING ----
Actuator reached lower force limit
ID = 2