标题: 总是出现问题 [打印本页] 作者: rengangfeng 时间: 2010-7-5 23:26 标题: 总是出现问题 在跑的时候就会出现这个错误 望大侠帮忙解决一下！！！ WARNING 701380 ** Warnings were reported in the model.
Mesh quality may be poor.
Co-ordinates of mold extremity:
X Y Z
Center -35.07672 mm -15.70879 mm 65.22000 mm
Right corner 242.92995 mm 262.29787 mm 343.22667 mm
Left corner -313.08338 mm -293.71545 mm -212.78667 mm
** ERROR 701580 ** Orientation of two adjacent elements is inconsistent.
Angle between normals = 9.00000E+01 deg degrees.
** ERROR 701590 ** Check the orientation of element 5302
** ERROR 701590 ** Check the orientation of element 24641
** ERROR 701580 ** Orientation of two adjacent elements is inconsistent.
Angle between normals = 1.76478E+02 deg degrees.
** ERROR 701590 ** Check the orientation of element 5499
** ERROR 701590 ** Check the orientation of element 24640
** WARNING 98000 ** The following warning messages occurred more than 5 times:
Message No. Number of occurrences
701360 100
** WARNING 98000 ** The following warning messages occurred more than 5 times:
Message No. Number of occurrences
701360 100 [img]file:///C:/DOCUME~1/ADMINI~1/LOCALS~1/Temp/)75N2NWKR]RF17ID@[M%{QJ.jpg[/img]