谁有法兰克后处理不带自动换到的麻烦给个，谢谢！

%1000
G40 G80 G94 G17 G90 G44 G98
( " p5 " )
( "  Part Operation.1 " )
( " IMSPPCC_MILL PPTABLE 06-13-2003 " )
( " OPERATION NAME : Tool Change.5 " )
( "  Start generation of : Tool Change.5 " )
( " R0.5 " )
G28 G91 Z0.
G00 G54 G90 X0 Y0
T3 D3
M06
( "  End of generation of : Tool Change.5 " )
( " OPERATION NAME : Curve Following.1 " )
( "  Start generation of : Curve Following.1 " )
S5500 M03
X4.499 Y11.043
G43 Z16.473
Z-3.527
G01 X3.078 F1200. M08
G00 Z16.973
X5.052
Z-3.527
G01 X5.13 Y10.686
X5.288 Y10.471
X5.525 Y10.4
X5.683
X5.919 Y10.471
X6.077 Y10.686
X6.156 Y11.043

后处理出来不要有换到指令  T3 D3 M06,这些换到的

xiamenkejigroup 发表于 2012-7-31 20:30
后处理出来不要有换到指令  T3 D3 M06,这些换到的

麻烦给个，我的邮箱ugpowermill@163.com,或是QQ邮箱      1552872440@qq.com