iCAx开思网

标题: thicken sheet // hollow 等问题 [打印本页]

作者: dyee 时间: 2005-2-18 12:56
标题: thicken sheet // hollow 等问题

初学造型经常会用到增厚或挖空，在下常会碰到出错，不论先做实体再挖空或先做薄体再增厚。不知道是程序的BUG，还是需要啥窍门，刚看到XYI发的《我是菜鸟，请问怎样才能将3根线联成一个顺滑的面？》，https://icax.net/cgi-bin/ut/att.cgi?aid=2668811&bid=4
下了他的IGS文件试了下，还是同样结果。UG中错误分析：Error data: ifail = 0 , state = 17002

Surface failed to offset or face could not be deleted

Minimum radius value  =    0.214463041
was found at 1 point  located at coneheads with solid font
Minimum radius value  =    0.421384616
was found at 1 point  located at coneheads with dotted font

拜托各位大虾指点下！！

上面链接为XYI的下栽，在下再贴一下

作者: vodka 时间: 2005-2-19 04:02
这个怎样？

欢迎光临 iCAx开思网 (https://www.icax.net/)