* A region at coordinates X-64.749 Y-32.523 Z-41.000 is too small to mill with 'Corner Milling - All Round'
Either reduce the 'Min. Radius' or use 'External Round'.
* A region at coordinates X-64.749 Y-32.523 Z-41.000 was NOT milled.
In order to prevent cutter breakage, all regions below were not calculated.
* AT X = -59.056, Y = 35.478, Z = -41.000 CONTOUR FOR MILLING OR FOR RAMP ANGLE IS SMALLER THAN PLUNGE SIZE.
NO MILLING WILL TAKE PLACE IN THIS LAYER!!!
* AT X = 59.347, Y = 35.167, Z = -41.000 CONTOUR FOR MILLING OR FOR RAMP ANGLE IS SMALLER THAN PLUNGE SIZE.
NO MILLING WILL TAKE PLACE IN THIS LAYER!!!
* A region at coordinates X64.749 Y-32.696 Z-41.000 is too small to mill with 'Corner Milling - All Round'
Either reduce the 'Min. Radius' or use 'External Round'.
* A region at coordinates X64.749 Y-32.696 Z-41.000 was NOT milled.
In order to prevent cutter breakage, all regions below were not calculated.
* PROCEDURE EXECUTION END TIME : 14/05/2005.09:31:00
*
* PROCEDURE VOLUME MILLING-SPIRAL CUT - 3D = 3 IS REPLACED
*
发表于 2005-5-14 10:51:45
QQ好友和群
QQ空间
腾讯微博
腾讯朋友
收藏
淘帖
赞一下！
发表于 2005-5-15 08:45:53