懂模具英语的高手请进的！！！！急

1.ADD GUIDE PILALR & BUSH DETAIL IN SECTION VIEW....

3.LOCK EJECTOR PINS AS PER 3D PART PROFILE.....
4.EJECTOR KNOCK-OUT HOLE IS MISSING  HERE
6.ADD ADDITIONAL SCREW BETWEEN BOTTOM PLATE WITH SPACER BLOCK....
7.ADD 3D PRODUCT ISO VIEW HERE.... FRONT & BACK SIDE.... &  ROUGHLY INDICATE ANY POST-OPERATION DETAIL OR ELSE... KEEP IN MIND FOR FUTUER PROJECTS ALSO...
8.ADD SHRINKAGE DETAIL IN TITLE BLOCK
9.ADD STEEL O-RINGS TO CONTROL WATER LEAKAGE....
10.INCREASE SLIDER TOP WEAR THICHNESS...
11.INCREASE SLDIER BASE LENGTH.....  SLIDER BASE LENGHT SHOULD BE CALCULATED BASED ON SLIDER HEIGHT (MIN +1.5 TIMES)....
13.BASED ON SLIDER MOVMENT ADD HASCO STD BALL CATCH FOR SLIDER STOPPER......
14.ADD SLIDER BOTTOM WEAR PLATE
15.FOR BETTER LOCKING ADD 2 SET SCREWS
16.ADD MANY HASCO STD REST BUTTON, Z55  BEHIND THE EJECTOR BACK PLATE
17.KEEP 3.0 mm GAP BETWEEN BOTTOM PLATE & EJECTOR UNIT...
18.ADD EJECTOR GUIDE DETAIL IN PLAN VIEW....
19.ADD EJECTOR GUIDE COUNTER BORE ON CORE PLATE
20.COOLING CHANNELS SHOULD BE IN DIFFERENT COLOUR IN PLAN VIEW & SECTION VIEW.... FOR BETTER VIEWING.....
21.WHY YOU NEED SUCH A BIG SLIDER MOVMENT.... ???????? DOUBLE CONFIRM SLIDER MOVMENT BASED ON 3D PART UNDERCUT & OVER FLOW DISTANCE !!!!
22.ADD ADDITIONAL SUPPORT PILLAR HERE
23.ADD EJECTOR PLATES LOCKING SCREWS IN PLAN VIEW...
24. ADD  EJECTOR PINS & SCREW HEAD + COUNTER BORE DETAIL IN PLAN VIEW.... THEN ONLY WE CAN DECIDE THICKNESS & ETC..... KEEP IN MIND FUTURE PROJECTS ALSO....
25.ADD EJECTOR PINS HERE & MOVE SOME PINS ....
26.CHANGE OVER FLOW DETAILS AS PER OUR MOULD FLOW  REPORT....

你这是招苦力啊？ 你自已不明白的地方到底在哪里？

从内容看你们客户对这份图纸是很不满意哦，很多基本的东西都没弄好。

先试试吧，不怎么完整。